The wiring diagram shown is a typical installation.
To operate the Auto gage Shift-Lite The Auto gage & tachometers works on the following. A tachometer is a good addition to any vehicle equipped with a manual transmission. In my Jeep CJ-7, I didn’t have one of those rare factory tachs so I chose the. A tachometer is used to indicate the revolutions per minute (RPM) being with a tach setting to test the wires correctly, and consult the shop manual for your.
As a safety precaution the RED wire of this product should be fused before connecting it to the positive (+) side of switched power source. We recommend using.
Pass tach wires through shock strap assembly and slide tach casing into shock as shown in the diagram in the Wiring section and only set the High Shift Point.Wiring your new Autometer tachometer into your car will complete the installation. Once you have selected a mounting location, you can run the four wires that operate the tachometer. The tachometer is designed to show the engine RPMs or rotations per minute.
Installation of the Autogage Tachometer was fairly simple with only minor wiring including a wire to the distributor, a good ground, a 12 volt switched power source and a wire to power the tach’s light. Autometer Autogage Tach Wiring Diagram It also will include a picture of a sort that may be seen in the gallery of Autometer Autogage Tach Wiring Diagram.
The collection that consisting of chosen picture and the best amongst others. INSTALLATION INSTRUCTIONS 5″ Tachometer WIRING Green White Red Dash Electronic ignitionLighting Fuse (See caution below) or Tach output on * See “Warning” below Ignition Switch tachometer, check with the ignition box manufacturer for recommended tachometer signal location.
Find great deals on eBay for autogage tach. Shop with confidence.Tachometer Installation Autogage Tach InstallWiring Diagram for Autometer Tach – schematron.org
