(03) Fax: (03) Notifier Inertia Pty Ltd (A.C.N ) PAGE 2. / INSTALLATION AND PROGRAMMING MANUAL.
COPYRIGHT © , NOTIFIER WIRING CONTROL MODULES (CMX-2). TERMINATION OF MODULES. SCS-8 FAN CONTROL MODULE ANNUNCIATOR.
guide. Refer to the control panel installation manual for detailed This module can be used to replace a CMX-2 mod- ule that has compatible Notifier system control panels only (list available from 2 mA Maximum (using internal EOL relay).
Division of Pittway Corporation MMX-1(A) MONITOR MODULE, CMX-2(A) Refer to the appropriate Notifier Installation Manual for detailed system information. (03) Fax: (03) Notifier Inertia Pty Ltd (A.C.N ) PAGE 2. / INSTALLATION AND PROGRAMMING MANUAL.
COPYRIGHT © , NOTIFIER WIRING CONTROL MODULES (CMX-2). TERMINATION OF MODULES. SCS-8 FAN CONTROL MODULE ANNUNCIATOR.
Refer to the appropriate Notifier control panel installation Note: Some panels support This module can be used to replace a CMX-2 mod- A ule that.Disconnect power to the control panel before installing the modules. appropriate wiring diagrams.
Notifier CMX-2 Addressable Control Module
2. Set the address on the module per job drawings. Note: Some panels support extended addressing.
In order to set the module above address 99 on compatible systems, carefully remove the stop on the upper rotary switch with thumb in the direction. ® Division of Pittway Corporation MMX-1(A) MONITOR MODULE, CMX-2(A) CONTROL MODULE, AND ISO-X FAULT ISOLATOR MODULE INSTALLATION INSTRUCTIONS This information is included as a quick reference installation guide.
typical 4-wire fault tolerant initiating circuit configuration, nfpa style d cmx-2(a) control module wiring diagrams communication line connect modules to listed compatible notifier control panels only from panel or previous device all wiring shown is supervised and power limited 32 vdc max. LED indicator. This module can be used to replace a CMX-2 mod-ule that has been configured for supervised wiring operation.
Compatibility Requirements To ensure proper operation, this module shall be connected to a compatible Notifier system control panels only (list available from Notifier). Mounting.
communicate with a Notifier analogue addressable system. As a result existing nonaddressable loops can be integrated into a Notifier addressable system The module monitors a zone of two-wire non-addressable smoke detectors. Each MCZR uses one of 99 available module addresses on a loop.NOTIFIER CMX-2 ADDRESSABLE CONTROL MODULE – RYBB Fire Alarm Parts, Service, & Repairs(Preview) Notifier – MMX-1(a) Monitor Module CMX-2(a) Control Module and ISO-X – [PDF Document]
