So all weekend I have been testing things and adjusting wiring, and making sure that I removed all the Solid state relays from the car, and now the infinity seems to . I was bench testing the Hella SSR (H) and found the cause of it. So all weekend I have been testing things and adjusting wiring, and making sure that I removed all the Solid state relays from the car, and now the infinity seems to .
I was bench testing the Hella SSR (H) and found the cause of it. If it’s not really about tuning or wiring.
1 x Hella Solid State Relay with pins connected as follows: “87” = Fuel Pump “86” = ECU aux2 “85”. Mini ISO Relay – H / Features: 12 Volt; SPST / Form A; Solid State Switch; 20 Amp Continuous; Sealed Cover.
Battery disconnect relay and solid state relay 12V, make contact. ..
Make relays are used to close an electric circuit between a power source and one or more.Dec 14, · “Hella solid-state relays have standardized housing dimensions and pin bases, allowing them to be used as an alternative to electro-mechanical relays inside vehicles. “After reading these two statements I “assumed” (key word) they would be a plug and play deal. T.C.
The diagram below shows how to wire a solid state relay. Please note that the diagram refers to DC/DC type solid state relay (SSR). Solid State Relay (DC/DC): Connect (R) positive terminal to the push button switch.
Connect (R) negative terminal to the negative terminal on battery 1. Connect (L) positive terminal to the positive terminal on battery 2. This is a solid state relay, their application is somewhat specific.
Solid State Relays
You have to know how the solid state relay works and the voltage leak and trigger voltages to know if it will be correct for your application. its similar to swapping out bulbs in a car to LED bulbs/5(7).
Apr 21, · Re: Solid State Relay Wiring? by billr» Thu Apr 21, pm You probably need a pull-up or pull-resistor for the input; most MS outputs are sinking (to ground), so a pull-up most likely. testing with the Hella solid state relay to control most fuel, nitrous, line-lock and trans-brake solenoids and the Hella relay is well suited to these applications.
• When using a solid state relay to control a device that may have significant fly-back voltage such as most solenoids, LPE recommends connecting a Transient Voltage.12V 4 Pin Solid State Relay – 22AMegasquirt Support Forum (MSEXTRA) • Solid State Relay Wiring? (View topic)
