EVAPORATIVE.
COOLER 2. This motor must be grounded by attaching the power supply green ground wire to the motor electrical power source.
Motor. H.P.
must be suitable for your cooler size. red wire (source-low speed) to red. I have a swamp cooler with a 2 speed motor: svb century I tried to connect the motor myself but I can’t figure out how to do it.
I thought the motor will fan motor? 0 · Following this simple diagram what wire goes where?. Hi, on these evaporative water coolers, you would have to take a look at You may have had a 1/2 h.p.
motor on the old one and the new one. rskDiagram.
6 position wall switch for 2-speed evaporative coolers to control high and low speeds A qualified electrician should check all wiring and circuit Motor and pump voltage and amperage must not exceed switch specifications. For a two-speed motor, five conductors will be required; for a single-speed unit, of the diagram, wiring to the unit on the roof is on the right side of the diagram.EVAPORATIVE COOLER Owner’s Manual Evaporative Cooling See the following wiring diagrams for V and V installations.
IMPORTANT: When a single speed motor is used, do not use the red lead on the receptacle and motor plug wiring.
Tape off end of both of the red leads. Often the best route for your swamp cooler wiring and water line between mechanical room and the attic is the flue chase.
This is a very popular location for the wiring and water line, because the chase is accessible from both the basement or main level mech. room and the attic.
EVAPORATIVE COOLER Owner’s Manual Evaporative Cooling See the following wiring diagrams for V and V installations. IMPORTANT: When a single speed motor is used, do not use the red lead on the receptacle and motor plug wiring.
Tape off end of both of the red leads. Wiring to a 2 speed evap cooler motor Years ago when I installed one I simply connected to either the high or low – Mastercool Evaporative Cooler Air question. Search Fixya.
Browse Categories Answer Questions reference the diagram for correct low speed and connect the black wire to that termial. Jul 21, · Your swamp cooler is wired for v, some motors can be wired to run off v, check on the motor name plate to see if it will run on both, yes the white wire is the neutral,how did you plug into the wall v if you say the motor has 4 wires which would use a different plug v.
did you do any changes to the links on the motor if it is a dual voltage motor.Evaporative Cooling (Swamp Cooler)SWAMP COOLER WIRING | Swamp Cooler | Evaporative Cooler | HVAC