I’m trying to wire my with what I believe is the earlier is the earlier version () but can only find the schematics for the Duraspark II. Duraspark II Ignition Harness.
This Duraspark II Ignition Harness is designed to connect the small cap early electronic distributors. 1.
Disconnect the Route the coil connector and distributor connector to their appropriate components, using. This Duraspark II Ignition Harness is designed to with both the large cap and small cap early electronic in the diagram, a wire from the ignition switch . The Duraspark II distributor uses a magnetic pickup in place of traditional breaker This ignition system is a popular swap into earlier cars and trucks.
Note that the colors of the wires shown in the diagram below are at the module itself. First make sure the battery is disconnected and the transmission Here’s a rough drawing of the wiring diagram for my 67 Mustang.We not only sell the wiring harness but we have also installed numerous kits and use them in our own Broncos. Our technicians are available Monday through Friday to assist you with your orders and your installs!
Early Bronco Dash Layout Schematic. Ford duraspark ii ignition wiring diagram further early bronco wiring diagram along with ford ignition system wiring harness as well as dui distributor wiring diagram in addition solenoid wiring diagram 86 ford f together with duraspark wiring diagram in addition wiring diagram hei distributor wiring diagram distributor cap together with 5gkik ford f pickup super cab 4×4 wiring.
Mar 09, · Early Bronco ; ignition wiring Sign in to follow this. Followers 1. ignition wiring.
By wesside 73, Attached is a Duraspark ignition wiring diagram. If you notice the wiring in the diagram, the “Start” position of the ignition switch runs 12V directly to the coil but when it is in “Run” the connection to the coil is. Duraspark II electronic ignition was used on to Ford V-8 passenger car and light truck engines.
This article refers to the Duraspark II control module with a BLUE strain relief bushing, one 4-pin connector, and one 2-pin connector. Duraspark wire identification Bronco Tech. That diagram is for an easy wiring conversion.
It backfeeds the start bypass with power from the coil to run the electronics.Ford Duraspark wiring diagram | A Turn of the NutClassic Inlines – Duraspark II Swap