Wiring Diagram He4 110.85866401

wiring diagram he4 110.85866401

Parts Diagrams (4) The voltage is measured across the black wire at P and the white wire on P Dryer Heating Element Wire Kit.

wiring diagram he4 110.85866401

I have a Kenmore Elite HE4 dryer # that won’t heat up: (I The third image shows the wiring diagram for this dryer with the drive. I have a Kenmore Elite HE4 electric dryer that has stopped working.

wiring diagram he4 110.85866401

If you don’t have a ohms meter simply pull the wires off and join them. try the OK- I see the panel in the schematic- it is the large panel at the bottom- but how do I open it?

. I have a kenmore elite HE4 dryer model and when I put wet.

wiring diagram he4 110.85866401

Parts Diagrams (4) Dryer Heating Element Wire Kit. Part: Dryer Terminal Block Screw Dryer Terminal Block Wire Set.

wiring diagram he4 110.85866401

Part: Electric Dryers: The thermal fuse is wired in series with the drive motor. If the thermal fuse opens, 91°C (°F), power to the motor is turned off.Thanks for the information about the dryer model , I will be glad to assist you.

wiring diagram he4 110.85866401

There is one thermal fuse and it is located on the back of the blower housing, there is also a thermostat located on the housing near the thermal fuse. Moved Permanently. Redirecting to schematron.org That wiring diagram shows that you should measure continuity through the light blue and white wires from the control board to check that motor circuit.

wiring diagram he4 110.85866401

If you have continuity through that circuit then you may need to replace that control board. You can order parts for the dryer through this page: Kenmore Elite HE4 Dryer Parts.

wiring diagram he4 110.85866401

When you remove the lower front panel, you should find the wiring diagram and test information in a plastic wrapper attached to the back side of the panel. You’ll be able to test and varify the dryer operation. This step-by-step dryer repair guide explains how to replace the heating element in an electric dryer.

wiring diagram he4 110.85866401

Because the heating element generates the dryer’s heat, check it if the air in the dryer doesn’t get warm. You can inspect the heating element for damage or breaks in the heating coil.Kenmore-Elite model residential dryer genuine partsCommon Dryer Symptoms | Symptom Diagnosis – Sears PartsDirect

wiring diagram he4 110.85866401