Compressor Start Device and Capacitor – Whirlpool W – This Assume the wires from defrost themostat were touching metal and shorted out. It wouldn ‘t so I replaced the overload relay with capacitor and that fixed the problem.
Found another diagram, showed it in refrigerator light area, took that apart, not. I needed to replace the relay start and overload protector on my LG refrigerator.
assembly and the overload protector connected to 3 wires (black, whirlpool switch relay part number W and the refrigerator runs. The thermostat inside the refrigerator tells the compressor when to turn on and turn off the current thermostat settings, the thermostat sends an electrical signal .
What start relay and overload do I need for this fridge? Also, do you provide wiring directions or would I have to rely on the schematic of the appliance?
The replacement part W should be a plug in replacement for the original. Compressor Start Device and Capacitor – Whirlpool W – This and the overload provides extra protection against excessive temperatures. 1 Installation Video 18 Installation Instructions Model Compatibility Found another diagram, showed it in refrigerator light area, took that apart, not there.Step by step instructions on how to replace a Compressor Start Device #W for Refrigerator made by Whirlpool, KitchenAid, Kenmore, Maytag, Magic Chef, Admiral, Dacor, Jenn-Air, Crosley, Amana.
Note: This video is intended to give you the general idea of the part replacement procedure. Your refrigerator is an older model and may have the wiring digram in a packet behind the kick plate in the front near floor.
Changing the defrost timer will not require use of a wiring diagram. Simply remove the old timer and replace the new defrost timer by plugging it into the wiring harness.
Step by step instructions on how to replace a Compressor Start Device #W for Refrigerator made by Whirlpool, KitchenAid, Kenmore, Maytag, Magic Chef, Admiral, Dacor, Jenn-Air, Crosley, Amana. Note: This video is intended to give you the general idea of the part replacement procedure.5/5(14).
Compressor Start Device and Capacitor – Whirlpool W – This includes both the run capacitor and the start relay. Found another diagram, showed it in refrigerator light area, took that apart, not there.
Yet another diagram showed it in the duct work area at back of refrigerator cabinet. Not there. Before detaching all the wiring /5(11).
Answer Carol, First check and make sure you have the proper voltage supply to the refrigerator, the off-on-off-on is most likely due to a weak or worn out / overload/relay kit, but the” too cold no matter what setting” is most likely because the end of the temperature bulb has been dislodged from the mounting on the control.FIXED Instructions for installing relay start and overload protectorHow to Test a Refrigerator PTC Relay: 7 Steps (with Pictures)