reprap:anet:electronics:mainboard the following heatdevelopement caused by improper wiring or currents going over the maximum rating for the connectors.
On my A8 (about a week old now) the bed had the wires doubled: two a crimp connector to the hotbed wires on the mainboard side as well. A8 3D Printer Installation Guide.
Page 2. A8 Assembly Instructions.
Attention: 1. Please make sure the package not .
Assembly Step Mainboard. I presented in another article some improvement for the Anet A8.
On the motherboard, unscrew the two power cables of the heating bed (left. Anet A8 printer assembly guide for the newbie V ANET A8 3D printer .
not fitted correctly on the switch or the connector not fully homed on the motherboard.Completely solve the hot bed power is too large and the load current issue. It can work with the Anet A8; With this addon module to your 3D printer motherboard you can lead the maximum current up to 15A; Under the premise of normal heat dissipation, this module can work steadily under the condition of I(Max)=15A. Don’t exceed 15A during the /5().
Hello! I’m new in this forum, and I came here to seek help for installing my new E3D-V6 to my anet A8.
The extruder came all installed, so the last thing I have to do is print the extruder support and connect it to the motherboard. Anet 3D Printer Board – Schematic and Board.
Contribute to ralf-e/ANET-3D-Board-V development by creating an account on GitHub. Just $, shop Anet A8 Desktop 3D Printer from GearBest USA Online Store, plus free delivery. Anet A8 printer assembly guide for the newbie V DC voltage wiring The power supply comes with a total of 3 pairs of connections each delivering 12V DC The connections are either marked +V and Com or +V and -V as shown below In both cases V+ = 12V positive and in the case of -V / Com this is the negative (ground).MOSFET wiring on Anet A8 | 3D Printing | Pinterest | Wire, 3D Printing and Arduinoelectronics – Connecting an inductive sensor to the Anet A8 – 3D Printing Stack Exchange
