In researching the Edelbrock I discovered some things on my set up don’t quite match the Edelbrock Diagram or some of the online. Well according the Edelbrock the tranny vacuum hose goes to the drivers .
But my vacuum lines are hooked up this way: drivers side valve. Started to bone up on my Edelbrock carb before adjusting it and noted this page in the manual which shows two distributor vacuum ports: Left.
Just bought a edelbrock CFM 4BC to replace my holly carb and shows exactly where you should hook up your vacuum lines. Tech / General Engine – which vacuum line is for timing on an edelbrock carb?
the part time vacuum. what you may want to do is find a vacuum diagram for the.The purpose of the EGR port is to feed exhaust gas from the exhaust system back into the intake air flow whenever the coolant temperature is high enough and the ported vacuum is also high (ie, not during startup and only during heavy loads or hard acceleration).
Buy Edelbrock Carburetor Inlet Fitting: Carburetors & Parts – schematron.org FREE DELIVERY possible on eligible purchases. Studebaker Technical and Troubleshooting Information (Serving the community since ) (This is a compendium of information, mostly from Internet. This Tech Section has grown rather long and takes too much time to load.
So, it was split into TWO PAGES, each page with the same index. Some content CAN be on the OTHER page and you will be directed back and forth transparently, as required.
The Edelbrock Performer Square Bore Air Valve Secondary Electric Choke New Carburetor features a two-piece, all-aluminum construction for cooler operating temperatures and less warping.Edelbrock Vacuum Lines – Hot Rod Forum : Hotrodders Bulletin BoardVacuum Line Routing