Enco says they are on back order and can’t give me a delivery date plus the Does your lathe have an electrical schematic in the manual?.
Items 1 – 8 of 8 Machinery Manuals | Parts Lists | Maintenance Manual | Service Instructions | Schematics: Enco – Buy and Sell Enco Operations Manuals. Items 1 – 8 of 8 Machinery Manuals | Parts Lists | Maintenance Manual | Service Instructions | Schematics: Enco – Buy and Sell Enco Operations Manuals.
I purchased an enco Model # 13×40 lathe and am having problems wireing it up v . Here is the manual I recieved with machine.
This manual provides critical safety instructions on the proper setup, operation The owner of this machine/tool is solely responsible for its safe use.Oct 26, · Would $ be a good price for a used ENCO lathe? Looks to be in good shape from the pictures.
Comes with steady rest and QC tool holder. I am trying to do an inspection tomorrow. I gutted the panel and replaced all of the wiring and electricals with new from Amazon and eBay.
So, if you haven’t seen the machine yet, make sure to check. Jul 17, · Enco Lathe Contactor wiring.
Thread starter cboyce; Start date Aug 22, [3] I had originally sent him a copy of the wiring diagram that was the same layout as his but did not work. Can the Enco Lathe be connected to ?
Oct 05, · I purchased an Enco 9×20 lathe, and when I went to set it up, the tag on the cord says it was wired from the factory for , and to look inside the motor wiring cover for directions. of this lathe. 1.
This machine is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe use of lathes, do not use this machine until proper training and knowledge have been obtained. 2.
Keep guards in place. Safety guards must be kept in place and in working order.
3. strength) into four holes (A, Fig.
1) of lathe stand. Sling the lathe with properly rated straps.
Do not lift by spindle. With adequate lifting equipment, slowly raise the lathe off the shipping crate bottom. Make sure lathe is balanced before moving.
5. To avoid twisting the .Control Switch for Enco LatheEnco Model motor wiring – The Home Machinist!
