To replace fluorescent light tube with LED light tube, the wiring must be connection for new branch circuit wiring required and shown as in diagram above.
7. Wiring Diagram of Single Tube Light Installation with Electromagnetic Ballast Fluorescent Lamp and Working Principle of Fluorescent Lamp.
To replace fluorescent light tube with LED light tube, the wiring must be connection for new branch circuit wiring required and shown as in diagram above. 7.
As we know the tube light is a low pressure mercury vapor gas discharge lamp or otherwise called as fluorescent light and mostly produce. This post “Fluorescent Light Wiring Diagram | Tube Light Circuit” is about how to wiring fluorescent light and “how a Fluorescent Tube Light works”. The wiring.Wire the positive lead to one of the leads on the side marked “LIVE END.” Wire the negative lead to the other lead on the LIVE END lamp holder. Be sure to secure all connections with wire nuts.
Once all the new, non-shunted lamp holders are wired on the LIVE END, reconnect the luminaire to the power source. Connect the red wire (sometimes can be brown) which is always the Live Wire to the ballast, and the black wire (sometimes blue) to the other terminal.
The light will still work if you wrongly connected these wires, but when it comes to maintenance, it will not be so easy to check for faults in the ballast. A) Note: only one PIN is Hot Wire, the remaining PINs are cold wire Fixtures with Ballast and Starter.
T8 LED Wiring Instruction Diagram (with NO Ballast) 1) Hot (black) wire (V live wire) to any pin on one end of troffer. 2) Cold (neutral, white) wire to any of other three pins on troffer.
3) Insert T8 LED Replacement into luminaire. A wiring diagram is a simple visual representation of the physical connections and physical layout of an electrical system or circuit. It shows how the electrical wires are interconnected and can also show where fixtures and components may be connected to the system.
Find the white wire coming from the main service panel and connect it to the white wire on the cable using a wire nut. Screw the switch back to the electric box and re-attach the switch cover. Turn on the main service panel and the switch to test if the light fixture works.Sign Ballasts | Smart Wire | Parallel Wire | Keystone TechnologiesT8 LED Bulb Replacement Wiring Instructions, specs from schematron.org
