

u x connection gm blower motor works on one speed only auto repair facts modelmars wiring diagram motors ge motor s vintage question . Mars® Mars® Mars® PSC Direct Drive Furnace Blower Motor, VAC, A, NEMA 48, 1/3 hp, rpm.

Brand:Mars®; CGI PN. Wiring was hard to figure out, so if your old blower motor has a white wire, I suggest a different replacement because MARS (1/3HP RPM VAC.

There should be a schematic printed on a sticker on the motor. Without knowing the make and model, or looking at the diagram.

I'm guessing. Gentlemen, I have a GE PBS fan motor.

I find replace it with a Mars fan motor. GE has five wires, BRN, YEL,PUR,BLK,RED.Direct Drive Blower Motors 51 2 inch dia.

MARS SERIES Direct Drive Furnace Blower Motors MARS direct drive furnace blower motors are three speed standard efficiency models. All models are electrically reversible and include 2 1/4 inch resilient rings for base mounting.

These models have all angle sleeve bearings and have open air over. / VAC Single Phase Most homes receive single phase power from the utility company. The utility company provides a VAC RMS line and a matching opposite line which is .

Wiring was hard to figure out, so if your old blower motor has a white wire, I suggest a different replacement because MARS (1/3HP RPM VAC 60Hz) does not/5(6). I replace the blower motor with a MARS 4 wire and my unit only has 3 wires. I think I have wired wrong because it runs for 15 minutes and cuts off but the outside unit still runs.

The motor I replaced it has 4 wires yellow, black, blue and red. blk-HI, blu-MED, and red .

FURNACE BLOWER MTR 1/4 / VAC Single Phase Most homes receive single phase power from the utility company. The utility company provides a VAC RMS line and a matching opposite line which is degrees shifted from the first line.50 Élégant Mars Graphiques - OBJECTIF PLANETE MARS - OBJECTIF PLANETE MARSMars Brand Blower Motor 1/3 HP volt #
This topic is simply matchless :), very much it is pleasant to me.
Excuse, that I interfere, but you could not paint little bit more in detail.
Your phrase is matchless... :)
In my opinion you are not right. I can defend the position. Write to me in PM.