pump is used it is usually located where the water is deepest in the bilge while the boat Wire. Brown.
Wire. Rule.
Rule – Identifying the 3 Wires on the Rule Bilge Pumps
Pump. Panel Switch. On.
Off. Step 8: Wiring The computerized, automatic system ensures that the vessel is always pumped.
I have a 25s and cannot figure out how to get the automatic feature to function. Here is the problem. When I connect the black wire to the.
Through advanced electronic technology, Rule Automatic Bilge Pumps eliminate the Brown with white stripe wire connects to the manual side of the switch. 3. Two Position Panel Switch.
One Gray wire from the float switch connects to the solid Brown (Positive) wire from Non-Automatic Bilge Pump. The Third wire needs.
I’ve installed a new Rule-Mate Fully Automated Bilge Pump GPH The brown wire should be attached to the automatic side of the switch.Lead wiring up. It is essential to get the pump wiring out of the bilge as quickly as possible. Run the wires up and secure them so that they do not sag into the bilge water.
Don’t skimp on wire size. A 3, gph pump will draw 15 amps, typically necessitating gauge, or maybe even 8-gauge wire.
Switch mounted too low. If the pump is sucking air and the automatic switch has not reached the OFF position, then the switch may be mounted too low for the pump and should be reinstalled 1/4″ to 1/2″ higher than the pump base.
Storage The pump may be left in the bilge all winter without damage, but must be disconnected from the battery. Shop, read reviews, or ask questions about RULE INDUSTRIES Rule-Mate Automatic Bilge Pump at the official West Marine online store.
Since , West Marine has grown to over local stores, with knowledgeable Associates happy to assist. For detailed installation and wiring instructions, see the Rule-Mate Instruction Manual.
WARNING: /5(). Sep 11, · I have a 25s and cannot figure out how to get the automatic feature to function. Here is the problem.
When I connect the black wire to the negative terminal and the brown(no stripes) wire to the positive, the pump works fine. But when I connect the brown striped wire (The automatic wire) to the positive terminal, the pump does nothing.
Pump design eliminates the need for a separate float switch to activate this RULE bilge pump. When power is supplied the start/stop mode for this unit is completely automatic.
Pump checks for water every /2 min. by turning ON for a second and measuring the load against the impeller.Rule Automatic Pump and Switch.
– Cruisers & Sailing ForumsRule Pumps, Water Pumps – schematron.org