Hello guys i am trying to wire my automatic rule into the switch on the else had this trouble with the auto bilge pumps thanks Gordon. The automatic pump has 3 wires - ground, positive manual and positive automatic.
For detailed installation and wiring instructions, see the Rule-Mate Instruction . Comments about Rule Industries GPH Rule-Mate Automatic Bilge Pump. Mate.
Bedienungsanleitung für Rule. Mate.
Manuale delle istruzioni per la pompa di sentina automatica. Rule Mate. Handleiding Rule Mate ISO / Electrically Operated Bilge Pumps Wires must be joined with butt connectors and ().
RM 12DC. (12v).
(). RM The Rule Mate series of Bilge pumps feature a solid state water sensing technology Rule Mate II series are available in , and Rule has been. Forum - Rule-mate auto bilge wiring - Replacing an old bilge pump that Wiring diagram only shows wiring for a 3-position switch (Man/Off/Auto).
. that way its always "on" automatic if battery, then use the switch to cut.Pump design eliminates the need for a separate float switch to activate this RULE bilge pump.
When power is supplied the start/stop mode for this unit is completely automatic. Pump checks for water every /2 min. by turning ON for a second and measuring the load against the impeller.
Rule Pumps RMA, All-in-one pump & switch (no float switch required), Automatic GPH submersible 12 volt DC bilge pump preferred by yachtsmen and commercial fishermen worldwide. The Rule Mate series of Bilge pumps feature a solid state water sensing technology that eliminates the need for a separate float switch.
Switch mounted too low. If the pump is sucking air and the automatic switch has not reached the OFF position, then the switch may be mounted too low for the pump and should be reinstalled 1/4" to 1/2" higher than the pump base.
Storage The pump may be left in the bilge all winter without damage, but must be disconnected from the battery. Rule Fully Automatic Bilge Pumps Manual.
FEATURES. activate the pump.
Once power is supplied, starting and stopping is completely automatic. The pump checks for water every 2 ½ minutes by running for a second and measuring load against the impeller.
If water is present, the MODEL GPH GPH24v GPH GPH. 1 product rating - Rule-Mate GPH Automatic Bilge Pump 24V RMA 3/4" Discharge $ Trending at $ Trending price is based on prices over last 90 days.Installing a Bilge Pump - BoatTECH - BoatUSRule-Mate Automatic Bilge Pumps
5 thoughts on “Rule-mate 500 automatic bilge pump wiring diagram”
Big to you thanks for the help in this question. I did not know it.
There are also other lacks
It seems to me, what is it already was discussed, use search in a forum.
And you so tried to do?
I am sorry, that I interrupt you, I too would like to express the opinion.