For more information on our complete range of American-made products – plus wiring diagrams, troubleshooting tips and more, visit us at schematron.org I need some help replacing an old Simple Comfort thermostat to a new Orbit I’m not sure what info that is needed, but the old wiring is. I’m replacing a Simple Comfort Thermostat with a Honeywell The Simple Comfort has the 24v wires installed.
The wires on the existing SC are. SC Non-Programmable Electronic Thermostat. Installation, Operation & Application products – plus wiring diagrams, troubleshooting tips and more.
Refer to Wiring Diagram in section 10 of this manual for assistance. Make sure NOTE–MODEL , NC: This thermostat is designed for use with Volt-AC low settings, simply follow the instructions below. Setting First ..
temperature is changed to that of the upcoming comfort program temperature. The start.3. Put thermostat base against the wall where you plan to mount it (Be sure wires will feed through the wire opening in the base of the thermostat).
4. Mark the placement of the mounting holes. 5.
Set thermostat base and cover away from working area. 6.
Using a 3/16” drill bit, drill holes in the places you have marked for mounting. 7.
SC Battery or Hardwired Non-Programmable Electronic Thermostat Installation, Operation & Application Guide For more information on our complete range of American-made products – plus wiring diagrams, troubleshooting tips and more, visit us at schematron.org • Configurable • Three Stage Heat Pump Systems • Backlit Display. Wire diagram to switch from a simple comfort to a rthc Wire diagram to switch from a simple comfort to a rthc Search this Question.
Share Check out some similar questions!
Wiring Honeywell RTHC thermostat [ 2 Answers ] I replaced my old mechanical thermostat with a Honeywell RTHC digital. My heatpump is an.
So I switched out a Simple Comfort thermostat twith a Honeywell RTH this summer when the thermostat went bad and all Home Depot had was the Honeywell. The A/C worked but never checked the heat (I live in Fla so A/C was critical at the time). IU tried to use the heat pump last night but will not start.
I think I didn’t get the wiring right. Aug 24, · replacing a simple comfort thermostat with a honeywell RTH The old had a blue wire connected to C terminal, but no C on the new terminal block. Instructions say not to connect.4/5.SOLVED: I’m looking for a thermostat to replace my simple – FixyaI need to replace a simple comfort thermostat what # – Fixya
