The solution is to get a photocell that matches the voltage configuration you have wired the outside light fixture for, and wire it according to the diagram.
The solution is to get a photocell that matches the voltage configuration you have wired the outside light fixture for, and wire it according to the diagram. Ensure that the photocell is functioning and is reacting properly with the light level changes by Wiring Diagram For Bluebox, Bluebox LT, PCC1 & PCC3.
a. Refer to the wiring diagrams below and choose the appropriate diagram.
b. Connect the Black wire (Hot Line) to the Black wire of the photocontrol.
c. Connect. Need a wiring diagram.
This device has an aimable sensor and automatically turns on in low light, adding safety and security to any space.4/4(). The light switch should always remain in the on position for the photocell to operate automatically. Turn the light switch off first to make sure the lights do in fact turn off to isolate the problem to the wiring at the photocell or the photocell itself. If the lights remain on with the switch off (Highly doubtful) you have something messed up.
Sep 24, · Wiring a photo cell is explained in the video. We show you where to attach the red wire, the black wire and the grounds. This photocell is used to control outdoor flood lights on the exterior of a.
4. Wiring Procedure: a.
Refer to the wiring diagrams below and choose the appropriate diagram. b. Connect the Black wire (Hot Line) to the Black wire of the photocontrol.
c. Connect the Black wire of the light fixture to the Red wire of the photocontrol.
d. For volt units: Connect the White wire from the light fixture and the White.Photocell Outdoor Lighting: schematron.orgInstall a Photoelectric Switch | schematron.org